AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
ROKS3 Flamethrower company of heroes 211/13/2023 The water jacket would be filled with about 4 liters of water from a small hole at the rear end, sealed by a cap.Ģ1. The tripod would be set up to make a firm base, often dug into the ground a little and perhaps with the feet weighted down with sandbags. The original design did not anticipate it being carried up jungle-covered mountains on men's backs, but such was the weapon's popularity that men were generally content to pack it to all manner of difficult locations. The Vickers Mk I was 13.6 kg without the water and tripod, and weighed 18.1 kg with the water. The gun and its tripod were carried separately and both were heavy. The Mark VIIIz cartridge, which had a boat-tailed spitzer “streamlined” bullet, could be used against targets at a range of approximately 4,115 m. The gun was 112 cm long and its cyclic rate of fire was between 450 and 600 rounds per minute. After purchasing the Maxim company outright in 1896, Vickers took the design of the Maxim gun and improved it, inverting the mechanism as well as reducing its weight by lightening and simplifying the action and using high strength alloys for certain components. The Vickers machine gun was based on the successful Maxim gun of the late 19th century. The machine gun typically required a six- to eight-man team to operate: one fired, one fed the ammunition, the rest helped to carry the weapon, its ammunition, and spare parts. 303 British (7.7 mm) machine gun produced by Vickers Limited, originally for the British Army. The Vickers machine gun or Vickers gun is a name primarily used to refer to the water-cooled. This support weapon was frequently used by many countries aligned with the Allies. Minors Axis Fiat M35 MMG.jpg (33.35 KiB) Viewed 549 times The Fiat Revelli Modello 1935 obtained a bad reputation on the battlefield, similar to the Breda 30, but in sharp contrast with the excellent Breda 37. Although the new Fiat machinegun obtained a significant modification, it proved to be a failed design with apparent deficiencies. The colonial troops, especially those deployed in Italian East Africa, still had some old FIAT Revelli mod.14 in service when war broke out. Although the conversion started in 1935, it took until 1940 to complete the replacement. The redesigned caliber now fired the more potent 8×59 mm RB Breda rounds. A lighter air-cooling system replaced the cumbersome water-cooling system, making the gun easier to handle. Fiat replaced it with a classical fee-belt, thus maintaining the ineffective oiling system. The new design eliminated the “cage” feeding system. In 1935, the conversion of old machine guns to the Fiat Revelli Modello 1935 began. Likewise, the later experienced these same problems. However, this created problems for the weapon in certain environmental conditions such as high concentrations of dust, sand, etc. A built-in oiling system lubricated the cartridges. This cage system involved a small box (the cage) filled with 10 Carcano clips (50 rounds in total). The feed-box did not use the classical feed-belt but instead used a curious “Cage” system. The FIAT Revelli mod.14 used the same cartridge as the Carcano 6.5×52 mm, which undoubtedly provided logistical advantages but made a less powerful weapon. This modified machine gun is the Fiat Revelli Modello 1935. In the late 1930s, the Italian army decided to refit its existing supply of Fiat Revelli Modello 1914 WW1 machine guns. This support weapon was frequently used by many Axis allied countries.
0 Comments
Read More
Leave a Reply. |